The HyperCube Evolution 3D Printer is a CoreXY printer inspired by the excellent HyperCube 3D Printer developed by Tech2C. The belt arrangement on that printer was the neatest CoreXY arrangement that I have seen. I have leveraged the great work that Tech2C has done to refine his design and incorporated this with my own further development to reduce the number of printed parts and simplify the build.
Upgrades for my Wanhao I3 PLUS
These are just a couple of designs that I printed and attached to better my 3D printer. These upgrades will be listed and explained down below:
LCD Cover
The LCD cover is hands down one of the most important prints I have done, The printer has its spot on my desk in my room and without the cover it shines a super bright light all through out the night. After attaching the cover to printer I lined the hatch with black electrical tape and made it so when the door it shut there is no light shining through the printed part keeping me up at night.
I3 printer feet
I designed these printed feet because after a while I have noticed that my table top was starting to get little scratches on the finish due to sliding the sheet metal on the desk. The feet have dense foam that is glued to the printed part that helps with moving it and also help reduce the noise from the vibration.
Filament holder
After trying my hardest to organize all of my filament spools I have noticed that it was impossible to keep them all neat. I designed a bracket that held 2 wooden dowels from Hobby Lobby and made it so the spools where neat looking and easily accessible.